reference Hexacopter + FCP-HL medium lift

[kinderkram]

Hmmm ... now I'm a bit confused.
Yesterday you told me that this is an error and that all Totals should be zero (except for throttle).

Anyway ... I'm pretty sure the ratteling is a mechanical problem and I need to replace the motors. They run completely different than all others when turned manually. Unfortunately no one has them in stock...

[JussiH]

[joebar.rc]

[kinderkram]

Don't worry - I wouldn't touch the values unless somebody tells me I should.

So far I only changed the magnetic values and the radio settings since Jussi used Spektrum and I use my Aurora with a multiprotocol PPM module.
That's when the error message appeared for the first time. But I skipped it bc I assumed it being part of the L1 magic.

Will try to lower k1 and see if it changes anything. Replacing the bearings is no job for me so I'll need to look for the motors elsewhere...

[bluuu]

Norbert:
Replacing bearings at T-Motors are very very simple.

Just drop out c-clip at bottom, pull the rotor, extract bearings, put in new bearings, put the rotor, place c-clip and ... done
5 minutes

[Jdmagoo]

I hope L1 will be available for the general public to purchase soon?

[joebar.rc]

[afernan]

Landing Leg T-16mm bars.zip

(103.58 KiB) Downloaded 653 times

This is my small contribution to a T-landing leg solution (see below)

Cost 10€ manufactured in Shapeways
. Material is laser sintered nylon plastic (black colour)

Once I check the real piece is right I´ll share the design to anyone that could interest it. Attached are 3dXML full detailed models (get a free 3dXML viewr here: )

[JussiH]

I have added the DXF´s for the Hardlander LG to my post about it on page9 now. Sorry for the wait.

[el-dentiste]