Page 1 of 1
QGC connection problem
Posted:
Wed Dec 02, 2015 11:22 amby luckpl
Hello
i have a QGroundcotol connection problem, my quad's USAR1 is broken, so i use USAR2 to connect the QGC.It can be connected successfully, but when I click some button to refresh the data on the QGC, sometimes there will be a failure or delay phenomenon,i am coufused, someone had the same issue?
thanks.
Re: QGC connection promblem
Posted:
Wed Dec 02, 2015 1:38 pmby aBUGSworstnightmare
Which Autoquad do you use (AQ6 or M4) and how is it connected to the PC (i.e. BT, other Radio module, USBtoUART, ..)?
Re: QGC connection promblem
Posted:
Thu Dec 03, 2015 2:16 amby luckpl
thanks for your reply
my autoquad is AQ6,and it connected to PC by blutooth.
Re: QGC connection promblem
Posted:
Thu Dec 03, 2015 5:07 amby Max
It could be a poor BT connection. Try with a USB adapter instead. How are you connecting to the 2nd serial port, do you have a DIMU installed? You may want to check all your connections, especially the grounds.
-Max
Re: QGC connection promblem
Posted:
Thu Dec 03, 2015 7:23 amby luckpl
Max:
I have tryed with the USB adapte,but it had the same problem.
I doubt that the USART2 can be used to connect to the QGroundcontro,or there are some special settings when use USART2?
Re: QGC connection problem
Posted:
Thu Dec 03, 2015 1:26 pmby aBUGSworstnightmare