Page 1 of 1
Hexa2 (MK.de) to autoquad hexa
Posted:
Tue Jul 03, 2012 4:57 pm
by plexus
Hello,
Because I have an old Hexa2 from Mikrocopter.de, my question is to know if it is possible to use the frame and the motors that are Roxxy 2827-35 with 10x5 propeller?
thank's.
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Tue Jul 03, 2012 5:58 pm
by kinderkram
Sure, you can do that.
AutoQuad FC and ESC32 are not limited to certain frames/motors/propellors.
The Roxxys will be good to go.
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Tue Jul 03, 2012 10:52 pm
by plexus
Ok many thanks.
But i am waiting your I2C solution to get the compatibility with the BL controler of the MK.
best regards.
Alain
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Thu Aug 09, 2012 5:12 pm
by Meez
you still can use your MK esc to become normal esc if you want. Just disolder C & D wire and tab it to ppm and ground point.
Cheers
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Thu Aug 09, 2012 5:54 pm
by kinderkram
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Thu Aug 09, 2012 11:27 pm
by plexus
Yes ok Kinderkram. But an other solution is to use the BL controler of the MK as said Meez.
question : at that time the FC AQ cannot work with BL of MK in I2C ? right ?
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Fri Aug 10, 2012 9:21 am
by kinderkram
No it can't. It wasn't meant that way.
The AQ6 will probably never support I2C control for MK ESCs.
- I2C is not as reliable as other solutions
- we'll focus on the CAN-bus
- we have better & cheaper ESCs to work with the AQ6 FC
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Fri Aug 10, 2012 4:25 pm
by plexus
Right, Kinderkram. It is not a problem.
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Sat Aug 11, 2012 4:06 pm
by Meez
Yea Kinderkram you're right. The I2C is not so reliable. Please do it another way with AQ Esc's. MK I2c seems very sensitif. My quad flipped over after reflashed with new firmware last week and i have to replaced 3 Esc due to I2c error and it didn't solve until now.
Re: Hexa2 (MK.de) to autoquad hexa
Posted:
Sat Aug 11, 2012 5:49 pm
by plexus