Need help : Futaba T10 CG w/ FRSKY CPPM ?

[Crizz]

Hi Folks, need your assistance

I´m using a Futaba T10 CP, modded to T10CG (native 2g4). I dont wanna use a PWM-PPM-Translator , but i have a FRSKY Receiver here which provides on CH1 a cppm for ch. 1-9 with total lenght of 20 ms. So, normally this should work.

Connected it to the Spektrum-sat-socket, power 5 V from board ( because it is specified for 3.5 - 10 V) , but get no channels shown in QGC though connect is established and have 2d gps fix indoor.

I´m in doubt that anyhwere the data protocol isnt compatible with AQ6, does anybody already tried the same configuration successfully, or how can i get rid of the problem w/o buying new rc ?

Any help is apprecciated

thx in advance !

)

[kinderkram]

Your receiver needs to be connected to M14, not the Spektrum port.
http://autoquad.org/wiki/wiki/autoquad- ... tions/#PPM
http://autoquad.org/wiki/wiki/autoquad- ... Connection
If you want to power the receiver you need to close the jumper on the 5V middele pin of M14.

[Crizz]

OMG - must have been blind ! Thx a lot, will try again tomorrow - and use M14 instead !

[Crizz]

couldnt just wait and been downstairs at my hobby room - works ! Just have to change the channel assignment and check for latest version of DIMU-FW, sunday will be good for that

thx again @ kinderkram !