My hex crashed

[bn999]

[zhlearnaq]

@Astudillo
hello Astudillo, i have the same problem as you now, i guess my press data are not good enough, do you use the MS5611 as your press sensor? My raw press data waved at the range of 50 while your data is less than 10, There must be some wrong. Have you found your reason?

[Astudillo]

@zhlearnaq

At the time i used the ms5611 baro, now i use the Dimu. In hindsight the problem was a combination of to much vibration witch gave resonance at a certain rpm, and a badly configured esc32(i had no limit on my current) that resulted in the crash.
The baro on the dimu works quite a bit better.

[zhlearnaq]

@Astudillo, Thank you very much for your reply, i have only ms5611 in my hand now