My status with the setup:
I did the static calibration, my radio is working with the board normaly.
The problem:
But When I arm the board and start the motors they to not started at the same time. One after the other start and all run toghether (but in a different speeds, the one that start first runs faster) when the throttle reach the 50% of the range.
Experience with other FC facing the same problem:
I remember I had the same problem when I mount my hexa with the Naza. To fix this I needed to changed (under the Motor Mixer tab of the software assistant) from Recommand to Low. Then all motors were synchronized.
What I did to try solve the problem:
I did the Throttle calibration range one after the other just with the escs and after that I tried to do with the FC pluged and armed, rádio on at full throttle turn on the escs, they were beeping, when the stick goes down 2 beeps saying the escs were ready. But nothing changed.
Under the Mixing Tab of the QG I have changed the settings of Motor/Esc Settings with many combinations but the motors still run one before the other. If I rise the value of Starting PWM all motors proportionally starts faster but not toghether. And the opposite when I decrease the number.
Setup:
Radio Turnigy 9X with FRSky
Frame Tarot Hexa F680
Escs DJI 30 amps (OPTO)
FC Autoquad
Motors T-motors MT2814-10 KV770