Default parameters.

[plexus]

I just finished my static calibration and now I want to load the defaults parameters in the AQ. How to do,because I dont see where they are.
Thanks

[GoFaster]

Hi plexus -

I'm not sure what you are asking. Have you done all the calculation steps? Or just the static and dynamic data logging?

Regards,
- Felix

[kinderkram]

No, plexus only did a static calibration so far.
The default parameters are the one you get after you flashed the firmware. Your values look good so you can proceed with the Calibso.

[plexus]

Ok, I done only the static calibration. The question is to known how to put the default parameters in the AQ board via the QGC.
I am coming from MK and in the MKtools the default parameters are inside. And I tought that was same thing with the QGC.
The default parameters are the one you get after you flashed the firmware Yes but how to see these values ?

[GoFaster]

[plexus]

ok ,many thanks. I will see that to morrow.